Configuring VRRP in ASA5525 between 2 site.

[maeh.ayi01]

I am looking for a VRRP "like" setup/config in ASA5525 firewall just like VRRP in routers.

I am building a lab where i have 2 site both sites are connected with each other with an ASA5525. Those ASA5525 are also the gateway for the rest of equipment. These 2 ASA5525 are also L3 (routing) functions to connect multip. VLANS together.

Is that possible if yes then where can i start?

When i write VRRP? in my ASA5525, it show this:

Error: % unrecognized command

[Jon Marshall]

You need to setup your ASAs as an active/standby pair ie they do not support HSRP/VRRP directly. 

Not sure which version of code you have but just do a search for ASA failover and you will see the relevant docs. 

Jon

[Karsten Iwen]

As Jon mentions, there is no VRRP (or HSRP) on the ASA. But depending on your needs and setup, you could also evaluate if the cluster-functionality has some advantages over the active/standby setup:

https://www.cisco.com/c/en/us/td/docs/security/asa/asa912/configuration/general/asa-912-general-config/ha-cluster.html

[kapydan88]

ASA doesnt support vrrp/hsrp. You need to use cluster (active/passive or active/active) or failover.