Connect two CEoIP Modules

[Ott0Wess0]

Hi

I have two 2811 Router with one NM-CEM-4T1 Module at each. Now I want to connect those with a E1 line to transport voice and maybe data (if it is possible).

Is this possible? If yes, what settings i have to do and what characteristics i have to look for?

Thanks

[Giuseppe Larosa]

Hello Otto,

these kinds of ports are specialized modules to carry one T1 over an IP backbone I would not connect them back to back they are thought to connect to TDM equipment.

Also they are probably more expensive then standard WAN modules.

if you want to carry a T1 over an IP backbone they are the right tool see the following link

http://www.cisco.com/en/US/docs/ios/12_4/interface/configuration/guide/hbbfeamo.html

Hope to help

Giuseppe

[Ott0Wess0]

Hello Giuseppe,

thanks for your answer, it helps me a lot. So i have to reconsider my task now.

Is there an other way to use this modules? And what do i need to connect my two router with a E1/T1 line?

thanks.

Otto