12-19-2008 02:37 PM - edited 03-04-2019 12:46 AM
We have 2 ADSL PPPoA. Configured to be bonded via Multilink PPP. Seems only one of the lines is active. I have attached the configs for both the 2801 and the 7206. Need help figuring out how to get both to function. We have this at Tac presently but they are having problems with it as well.
12-21-2008 03:50 AM
Hello Jason,
try to use under each virtual-template interface on the cpe
ip unnumbered multilink3
also I've found example where an ATM point-to-point interface is used
So another suggestion is to use point-to-point ATM subifs also on the CPE as you use them on the backbone router
This is important for the routing protocols also to have the same type of subinterface on both sides
see
http://www.cisco.com/en/US/docs/routers/access/1700/software/feature/guide/1700ADSL.html#wp31205
Hope to help
Giuseppe
12-22-2008 10:47 AM
12-22-2008 01:03 PM
Hello Jason,
I think it is fine.
just one note:
the ip unnumbered multi3 command will override the no ip address command under the two virtual template interfaces.
So don't worry about this it is normal
Hope to help
Giuseppe
12-22-2008 01:34 PM
Thanks Giuslar,
We'll inputting the changes on site in the morning.
Jason
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide