default-information originate on address-family multicast vrf

[Jérémy]

Hello,

I want use the command "default-information originate" on address-family multicast
But when I put it, the router accept the command but it's not present when I show running configuration

address-family ipv4 multicast vrf VPN1
redistribute connected
neighbor 10.4.4.2 remote-as 65400
neighbor 10.4.4.2 activate
neighbor 10.4.4.2 next-hop-self
exit-address-family

ip route vrf VPN1 0.0.0.0 0.0.0.0 Tunnel1 multicast

Thx

Regards.

Jérémy

[johnlloyd_13]

hi,

try the "show run all" and pipe to match the said command, i.e. "show run all | inc default-information originate"

[Jérémy]

Hello John,

No result when i use "show run all | inc default-information originate"

[MHM Cisco World]

are tunnel is in same VRF or in global ?

[Jérémy]

Tunnel is in same VRF

[MHM Cisco World]

are you sure?
there is different between the tunnel in vrf and source of tunnel in vrf.
which one you use 
are you use under tunnel 
ip vrf forwarding ?

[MHM Cisco World]

show ip route vrf 

are you see tunnel ip 
are you see default route ?

if you can not see both then the advertise is not happened because of this reason.

[Jérémy]

The adress-family is use on back to back
I have static routing for tunnel

Nominal :

interface GigabitEthernet0/0/1.4005
encapsulation dot1Q 4005
vrf forwarding VPN1
ip address 10.4.4.1 255.255.255.252
ip pim sparse-mode
no cdp enable

NR-4221-5#sh ip route multicast vrf VPN1

S* 0.0.0.0/0 is directly connected, Tunnel1

Backup :

interface GigabitEthernet0/0/1.4005
description --ROCADE--
encapsulation dot1Q 4005
vrf forwarding VPN1
ip address 10.4.4.2 255.255.255.252
ip pim sparse-mode

NR-4221-2#sh ip route multicast vrf VPN1

S* 0.0.0.0/0 [250/0] via 172.22.4.1, Tunnel1

[Georg Pauwen]

Hello,

I assume this is a 4221 router ? What if you configure the command under the router process ?

router bgp 1

--> default-information originate

!

address-family ipv4 multicast vrf VPN1
redistribute connected
neighbor 10.4.4.2 remote-as 65400
neighbor 10.4.4.2 activate
neighbor 10.4.4.2 next-hop-self
exit-address-family

[Jérémy]

Hello Georg,

Yes it's two 4221 routers

This command doesn't work under router process

NR-4221-5(config)#router bgp 65400
NR-4221-5(config-router)#default-?
% Unrecognized command

[MHM Cisco World · Accepted solution]

Bgp

address

neighbor x.x.x.x default-inf

this command we use 

but again if default is missing from routing table then it not work