DMVPN

[emadehsan]

hi dear all,

I have implement a DMVPN solution,one hub and about 5 spokes,the link between my spokes and the hub is E1 connection,

so I want add a wireless link between the spokes and the hub,now I want make the wireless link as a backup interface,I mean when the E1 get down the wireless link getup and again when E1 cames back the wireless link get into standby.

please guide me,

regards

[stephen.stack]

Hi,

A few questions for you?

Is the E1 from the Hub to the internet? and will the wireless link be to the internet too?

What internet connections do the spokes have.

If you configured the DMVPn with SDM then there is an option for both HUB and Spokes to configure a Backup solution.

Read more here

http://www.cisco.com/en/US/products/sw/secursw/ps5318/products_user_guide_chapter09186a0080655f7f.html

Cheers

Stephen

[emadehsan]

hello daer stephen

there is no internet link,

e1 and wireless just connect the spoke to the hub,

iu want make failover

[044102947]

Are you running routing protocol over your network.