01-24-2021 08:13 AM
dot1q-tunnel is not working on N3K-C31108PC-V
01-24-2021 08:24 AM
Hi @support
Q-in-Q is not supported on Nexus 3100:
https://www.cisco.com/c/dam/en/us/td/docs/Website/datacenter/platform/platform.html
Stay safe,
Sergiu
01-24-2021 08:19 PM
okay, but when I configured opposite port of dot1q as a access or L3 its working fine. Only for trunk port its not working.
01-24-2021 11:08 PM
Can you share the interface configuration from Nexus 3100 in both working and non working scenario?
Also, please share the "show logging log".
Cheers,
Sergiu
01-25-2021 03:03 AM
Non Working Configuration
SW-A and SW-C Conf:-
interface Ethernet1/1
no lldp transmit
no lldp receive
no cdp enable
switchport mode dot1q-tunnel
switchport access vlan 1043
mtu 9216
LOC-A and LOC-B Conf:-
interface Ethernet1/1
switchport mode trunk
switchport trunk allowed vlan 10,20
Working Configuaration
SW-A and SW-C Conf:-
interface Ethernet1/1
no lldp transmit
no lldp receive
no cdp enable
switchport mode dot1q-tunnel
switchport access vlan 1043
mtu 9216
LOC-A and LOC-B Conf:-
interface Ethernet1/1
description VLAN_10
switchport access vlan 10
Also, Between SW-A,SW-B,SW-C VxLAN is configure.
01-24-2021 09:02 AM
Can you post show version of the device and show us an example of what is not working.
01-24-2021 08:51 PM
01-24-2021 10:18 AM
Hello,
according to the link below:
--> Cisco Nexus 3000 Series switches (except for the Nexus 3500 Series switches) do not support configuring Q-in-Q Tunneling on Cisco NX-OS Release 7.0(3)I7(2) and the previous releases.
I guess that means you have to run a version higher than 7.0(3)I7(2).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide