Hi guys,
Just a easy question, my dsl plan should offer me a 24mbit connect but my Cisco 1801 only syncs at 11mbit.
the provider told me i live to far from the dslam. But when i check my dsl status my attenuation is 22db that should be enough to have a higher download speed right?
Rebel#show dsl int atm0
ATM0
Alcatel 20190 chipset information
ATU-R (DS) ATU-C (US)
Modem Status: Showtime (DMTDSL_SHOWTIME)
DSL Mode: ITU G.992.5 (ADSL2+) Annex A
ITU STD NUM: 0x03 0x2
Chip Vendor ID: 'STMI' 'BDCM'
Chip Vendor Specific: 0x0000 0xA341
Chip Vendor Country: 0x0F 0xB5
Modem Vendor ID: 'CSCO' 'BDCM'
Modem Vendor Specific: 0x0000 0x0000
Modem Vendor Country: 0xB5 0xB5
Serial Number Near: FHK092910VPCISCO73916702
Serial Number Far: Chip ID: C196 (0)
DFE BOM: DFE3.0 Annex A (1)
Capacity Used: 98% 100%
Noise Margin: 6.5 dB 6.5 dB
Output Power: 18.5 dBm 12.0 dBm
Attenuation: 22.0 dB 9.0 dB
Defect Status: None None
Last Fail Code: None
Watchdog Counter: 0x2C
Watchdog Resets: 0
Selftest Result: 0x00
Subfunction: 0x00
Interrupts: 4141 (0 spurious)
PHY Access Err: 0
Activations: 1
LED Status: ON
LED On Time: 100
LED Off Time: 100
Init FW: init_AMR-3.0.014_no_bist.bin
Operation FW: AMR-3.0.014.bin
FW Source: embedded
FW Version: 3.0.14
6dB or below is bad and will experience no synch or intermittent synch problems
