07-27-2008 02:25 PM - edited 03-03-2019 10:55 PM
Hello,
I have been trying to configure a Cisco 877 with ADSL and dynamic IP configuration but I get get always the same error with "debug dialer" [Di1 DDR: Cannot place call, no dialer string set.]
Please I need some help, It's like a joke, several years configuring enterprise routers and now I am not able to configure a home ADSL connection with a Cisco routers.. :)
Any idea ?? Thanks a lot !!
This is the config:
interface ATM0
no ip address
no ip route-cache cef
no ip route-cache
no ip mroute-cache
atm vc-per-vp 64
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
no ip route-cache
pvc 8/35
encapsulation aal5snap
pppoe-client dial-pool-number 1
!
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface Vlan1
ip address 192.168.1.66 255.255.255.0
ip nat inside
no ip virtual-reassembly
!
interface Dialer1
ip address negotiated
ip mtu 1492
ip nat outside
no ip virtual-reassembly
encapsulation ppp
ip tcp adjust-mss 1452
dialer pool 1
dialer-group 1
no cdp enable
ppp authentication pap chap callin
ppp chap hostname adslppp@telefonicanetpa
ppp chap password 7 06070B32405E1909
ppp pap sent-username adslppp@telefonicanetpa password 7 03055F180A1F315C
ppp ipcp dns request
ppp ipcp wins request
hold-queue 224 in
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Dialer1
!
ip http server
ip http secure-server
ip nat inside source list 102 interface Dialer1 overload
!
access-list 23 permit 192.168.2.0 0.0.0.255
access-list 102 permit ip 192.168.1.0 0.0.0.255 any
dialer-list 1 protocol ip permit
no cdp run
!
!
!
control-plane
07-28-2008 04:20 AM
Hello Ricard,
Config looks good, try saving the config and powering off/on the router. If no joy, Try this,
interface Dialer1
no ppp authentication pap chap callin
ppp authentication chap pap callin
If still doesnt work,
interface ATM0.1 point-to-point
pvc 8/35
no encapsulation aal5snap
no pppoe-client dial-pool-number 1
encapsulation aal5mux ppp dialer
dialer pool-member 1
Regards
07-28-2008 06:07 AM
The dialer-pool must be linked to the atm line with the following commands:
interface ATM0.1 point-to-point
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
regards,
Leo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide