e1/e3/t1/t3 configuration in show run

[Desmond Lee]

Hi, if I have already configured something like the below for my port-adaptor cards -

card type e3 2 0

card type e1 2 2

card type e3 3 0

controller E1 2/2/0

 channel-group 1 timeslot 1

..............................................

If one or more of the cards were to fail (hardware failures), will the card type x x and controller xx xxx

configurations remain in the show run configuration ?  Do I need to reconfigure them say I replace the faulty one with a working on the same slot/bay ?

Thanks

[Richard Burts]

If the card has been correctly configured and has been running successfully and then fails and you replace it with the same model of card then I would expect the existing config to work on the new card without requiring you to reconfigure anything.

HTH

Rick