EIGRP:Single Peering over Parallel Links

[martin_lx1980]

There are many links between two eigrp routers. A feature called single peering over parallel links could implement that only one neighbor relationship exists no matter how many links between the routers

But I don't know which command I need to implement this feature. I think it is not the default behavior for eigrp

Thanks a lot

Martin

[Peter Paluch · Accepted solution]

Martin,

You're probably reading the "Advances in EIGRP" document. Sadly, I haven't seen this feature implemented anywhere. Please correct me anyone if I am wrong on the subject but this feature, as it seems, never came into production.

Best regards,

Peter

P.S.: Martin, did I answer all your questions about the CR-mode? I admit I haven't kept an eye on the discussion for quite a time. If there are any unanswered issues please let me know.

[JohnTylerPearce]

Peter, I enjoyed the read about CR-mode, that was VERY interesting and learned a lot. Sorry to kinda hijack the thread here.

[martin_lx1980]

Peter, enjoy to see your reply again. Indeed I am reading "Advance in EIGRP"  document and see this feature introduced. But I could not  find any other document to specify this feature and also could not find any IOS command about this.

  I have full knowledge about CR-mode and thank you very much for your help. I expect to have more discuss with you if I have another confused problems.

Best Regards

Martin

[martin_lx1980]

     Peter, enjoy to see your reply again. Indeed I am reading "Advance in EIGRP" document and see this feature introduced. But I could not find any other document to specify this feature and also could not find any IOS command about this.

     I have full knowledge about CR-mode and thank you very much for your help. I expect to have more discuss with you if I have another confused problems.

Best Regards

Martin