Routing

Hi all,i am having 2 locations & having cisco 1841 & 2821 at both the end connected via a P2P link.Now when i trace location A from location B, the traffic is getting dropped at location A's Vlan HSRP IP address.there is no ACL in that Vlan, but stil...

Hello,We have three sites connected to each other over MPLS network through BGP protocol with various routes advertised. If a fourth site were to be added, how can I restrict the routes advertised by the other three sites in a way that only specific ...

Hi there,My ISP provide me a set of IP as below:Serial IP     : 210.187.x.x 255.255.255.252WAN IP     : 58.27.x.x 255.255.255.224I had setup a WAN router which as below:Router#sh runBuilding configuration...Current configuration : 2606 bytes!! Last c...

I recently set up a new eBGP customer's circuit, who'll be doing dual-homing with another provider. This customer has a CCIE running their network, and he's complaining that, when using a BGP route view server, his AS is not being prepended when it t...

I'm moving into a newdatacenter. I don't consider myself a network engineer or anything but I do understand the basics. The new data center I am moving into routes mynetwork to me a bit differently than my old data center, so I thought I'd post here ...

If I use a route-map to mark certain traffic and then set ip next-hop on that traffic, then use a route-map to NAT that traffic, can I match based on Interface even though I set the ip next-hop?In other words when using set ip next-hop will that also...

I'm  trying to install ios into my  cisco 2821 which boots in rommon.  Apparently the ios is corrupted, I  have set the IP_ADDRESS,  IP_SUBNET_MASK, DEFAULT_GATEWAY, TFTP_SERVER,  TFTP_FILE but anytime I  issue the 'tftpdnld' and confirm to continue,...

Hi Everyone, first post.I looking for a solution to a problem im having with access lists, i have no experience with them.Heres what i need if its not too much trouble  I have a  LAN with net address 192.168.1.0 attached to router alpha 192.168.1.1 a...

Hi there, im having trouble figuring out how to go about nat tanslation on a network im working on in packet tracer, this is the scenario i need to work out.I have one public class C licence (195.100.190.0/24). This is not sufficient for  complete in...

Hi,    what is the mechanism used to calculate the amount of traffic ( mbps ) a router can scale. I most of the cisco router uses distributed architecture & also there is a difference between the practical throughput value & theory value. Can any one...

I have an GRE Tunnel across my head office and remote site with multiple subnets using cisco 1841 routers.I can ping most of  the devices on the remote side, but I can not ping certain devices. These  devices respond to ping requests on the local LAN...