Error on Serial interface of WIC Card ?????

[afzaalq007]

Hi,

Some time i have seen Error on C-2600 on Serial interface's

That is

E1T1 NM Module Int S0/0:0 reciviing Excessisve errors.

what are the common reasons for this???

Thanks

[balajitvk]

Hi,

Could u mention the exact full error msg and software version so that it is easy to get into the probs???

Rgs

[afzaalq007]

Hi,

Thanks for the responose

the Full error is

%E1T1_Module-3-linefalp: Int S0/0:0 receiving Excessisve errord Pkacket

And the IOS verion of the router is 12.2(8)T5

Thanks

[balajitvk]

Hi,

%E1T1_MODULE-3-LINEFLAP: Interface [chars] receiving excessive errored packets

The serial interface is receiving an excessive number of error packets. This problem is caused by a controller configuration mismatch.

Check the settings for line code, framing, time slots, and speed.

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1831/products_system_message_guide_chapter09186a00800f71a7.html#1025390

Rate if it does,

Rgs