Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are using Catalyst 2950G-24-EI and have set the system MTU as max value 1530. This device is connected to 7606 router where jumbo frames are allowed and having the interface mtu as more than 9000. But i am not able ping from the switch to rout...
Hi,I copied & installed EY4 image distributed by my corporate office thro. ftp on my Cisco 3750 Metro Switch. I left the default image undeleted and tried to load this image, but it loades very very slowly and progress takes infinite time to complet...
Dear All,One of my 7609 Supervisor 720 Console is not responding to my inputs.... but showing logs and all. I am connecting this thro. Com1 of my laptops or PCs with hypertrm. Whereas my redudant sup is working fine and also i m able to login to con...
Hi, My Show module showing different status for two of my SPAs... Can anybody suggest what is that mean????Attached the show module and show version fyr.Rgs
Hi,Hope it is Ethernet drop from the mux directly! What is the end to end circuit speed??Did u tried connecting laptop on both side with auto option ??Rgs.
Hi Bharat,You can try the same in the below mentioned order.....shutmedia-type rj45speed { 10 | 100 | 1000 | auto } duplex { full | half | auto } no shutAfter changing the media type, configure the speed and duplex to appropriately match the new inte...
Hi,Hope the secnario is that you are getting 6 timed outs while doing the continous pinging and when one core switch is goes down.....It may be due to hello and holdtime time intervals for GLBP may be at default. 3 seconds & 10 seconds.....Rather if...
Hi,I don't see any such restriction for 6748 interface modules on Cisco 6509.....What error your getting while installing in other slot positions???Rgs.
