Error when copy flash to cisco Router.

[jomo frank]

I getting the following error when attempting to copy image to flash, it should be mentioned I use two different Tftp Server applications but the result the same

Bog#copy tftp flash:

Address or name of remote host [192.168.42.210]?

Source filename [c890-universalk9-mz.158-3.M6.bin]?

Destination filename [c890-universalk9-mz.158-3.M6.bin]?

Accessing tftp://192.168.42.210/c890-universalk9-mz.158-3.M6.bin...

%Warning: File not a valid executable for this system

Abort Copy? [confirm]

I have included additional information about the router for your guidance

Bog#sh ver

Cisco IOS Software, C800 Software (C800-UNIVERSALK9-M), Version 15.3(3)M5, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2015 by Cisco Systems, Inc.

Compiled Wed 04-Feb-15 11:24 by prod_rel_team

ROM: System Bootstrap, Version 15.2(3r)XC, RELEASE SOFTWARE (fc1)

Bog uptime is 1 week, 6 days, 3 hours, 56 minutes

System returned to ROM by power-on

System image file is "flash:/c800-universalk9-mz.SPA.153-3.M5.bin"

Last reload type: Normal Reload

Last reload reason: power-on

This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to

export@cisco.com.

Cisco C892FSP-K9 (revision 1.0) with 488524K/35763K bytes of memory.

Processor board ID FTX19138015

10 Gigabit Ethernet interfaces

1 Virtual Private Network (VPN) Module

DRAM configuration is 32 bits wide

255K bytes of non-volatile configuration memory.

250880K bytes of ATA System CompactFlash (Read/Write)

License Info:

License UDI:

-------------------------------------------------

Device#   PID                   SN

-------------------------------------------------

*0        C892FSP-K9            FTX19138015

License Information for 'c800'

    License Level: advipservices   Type: Permanent

    Next reboot license Level: advipservices

Configuration register is 0x2102

Thanks

Regards

[marce1000]

 - Make sure the correct image is being downloaded (double check on the router model)

 M.

[jomo frank]

Hello Marce,

I confirm the router mode is C892FSP-K9.

Regards

[marce1000 · Accepted solution]

 - As a sanity check ,try another release, preferably one of the suggested releases, check if the problem persists or not.

 M.

[jomo frank]

Hello Marce,

I found the error the model router  C892FSP-K9    has it own ios c800-universalk9-mz.SPA.158-3.M6.bin.

Thanks 

Regards