Dear Friends,
We are not able to find command for disable FLOW-CONTROL on cisco 7206 router Gig Port (output flow-control is XON, input flow-control is XON).
Cisco_7206#sh int gi0/2
GigabitEthernet0/3 is up, line protocol is up
Hardware is MV64460 Internal MAC, address is 001c.b0bb.d419 (bia 001d.c0cc.d728)
Internet address is 172.168.1.77/30
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 199/255, rxload 68/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 2d07h
Input queue: 0/75/7867/30 (size/max/drops/flushes); Total output drops: 1704
Cisco_7206#sh run int gi0/2
Building configuration...
Current configuration : 234 bytes
!
interface GigabitEthernet0/2
ip address 172.168.1.77 255.255.255.252
no ip redirects
no ip proxy-arp
duplex full
speed 1000
media-type sfp
negotiation auto
no clns route-cache
end
Router Model Is :- 7206VXR (NPE-G2)
We want to disable it as input errors are observed on this interface, but dopes'nt find a command for disable this.