Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts, I have seen a rule in our Voice Gateway which is applied with 987654. i.evoice translation-rule 1rule 1 /987654/ //!!voice translation-profile blocktranslate called 1For this i have searched on Cisco Support Community and saw reply comm...
Dear Experts,We have stucked with a redistribution scenerio of BGP-EIGRP & EIGRP-BGP.Connectivity is like, We have a core network of 4 EIGRP routers (R1-R2-R3-R4) and from R2 & R3 1-1 BGP configured Rts are connected respectively.redistribution comm...
Hi Netpros,We are a services providers, Many of our customers are using WI-FI at their LAN about which we also not aware. We want to apply a configuration at our core routers level after which users can't connect or authenticate thru their WI-FI. as ...
Hi Experts,What are the difrerence in different Ether-Channel TypeFor Eg:- ON , Auto Desirable , LACP, PagPAsking this b'coz we have a setup lets say End "A" & End "B" .End A having Cisco Switch & End B is non cisco .... recently we created Etherchan...
Hi Experts,1> What are Tagged & Untagged Vlans.If anyone can share with simple example.Is NATIVE vlan is Tagged or Untagged. and what about other vlans which are allowed in command "switch trunk mode allowed vlan 2,4,6,8". bt confusion on this. 2> Th...
Dear Sanda, Thanks ...!!! But as your replied "This rule is basicly saying anytime anyone dial "987654" it will become no digits". Question is -1. why the digit 987654 only. 2. why the rule is specific for no 987654.3. why should anyone call 98...
Hi Alain,Well, let me again try to make myself clear about the topology.We having a four EIGRP running rtr (R1-R2-R3-R4)EIGRP R1 is connected to a BGP-R2EIGRP R3 is connected to a BGP-R1EIGRP R2 & R4 are simply a EIGRP speaking router acting as a Tra...
Hi Alain,Configuration belongs to R2 (EIGRP Rtr (Edge Rtr which is connected to BGP Rtr-A). Same commands are configured at R3 (EIGRP rtr which is connected to BGP RTR-B).
Txns Jonathan for wspecific reply.But here what you meant by "Hard Coding Each end of etherchannel" "I would recommend using the LACP protocol (Channel group x Active/Passive) or simply hard-coding each end of the etherchannel with the "on" command."
Hii Chris n Peter,Txns a ton for reply.a small confusion here.If we want to define a Tagged & Untagged Vlan , can it be like this.Un-Tagged Vlan :- The Vlan which passes over the trunk is untagged Vlan.Tagged Vlan:- Vlan having dot1q header in their ...
