FMC/FTD AutoNAT to Public IP Addrees instead of Destiantion Interface

[info-sec]

Hi,
I am unable to add an AutoNAT rule to a 2nd Public IP part of our ISP block of 6 hosts.
I have multiple servers in DMZ where I want to translate each to a different Public IP
Can only Nat to the Destination Interface IP, and not to a new Address Public IP object.

Manual Static Nat doesn't seem to work either if I specify the source and translated specific ports to be opened.

[MHM Cisco World]

MHM

[MHM Cisco World]

Check this guide it better 

https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/212702-configure-and-verify-nat-on-ftd.html

MHM