Re: Getting an error on Cisco Router 881 ## Readonly ##

Mohammadimteyaz2 · ‎01-28-2018

Hello,

I am getting below error in cisco router 881.

C880 platform with 262144 Kbytes of main memory

Readonly ROMMON initialized
rommon 1 >

I am not able to type any command on rommon 1>.

please share your experience please

Julio E. Moisa · ‎01-28-2018

Hi

The cause might be there is a no valid or corrupted IOS or the config register is not 0x2102, try executing the command: boot and then press enter.

>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

Leo Laohoo · ‎01-28-2018

Post the complete output to the command "dir flash:".

paul driver · ‎01-29-2018

Hello

try-:
Confeg 0x2102

reset

res
Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Mohammadimteyaz2 · ‎01-29-2018

Dear all,

Thanks for your prompt replies.

at read only prompt i was not able to type any command so then i put it up and running state as it is for one day..... and now finaly i got the console password prompt..... hahahaha

now i am able to login...

Thank you so much to all.

Regards

Mohammad Imteyaz