Hello, Can someone please assist me in understanding the difference between Bandwidth of a GRE/VTI Tunnel vs the tunnel transmit/receive bandwidth. Here is the output for command show interfaces tunnel1 Tunnel1 is up, line protocol is up Hardware is...
Forum Posts
Scenario: 2 routers (R1 & R2) connected directly (point-to-point) via serial interfaces. Dual stack (IPv4 & IPv6). R1 is mine - I control it. R2 is not mine - I cannot control it or make any configurations on it. I want to be able to block IPv6 ICM...
We have an ASR1001X running BGP over an ethernet link to our MPLS provider. We have had occasional outages where BGP bounces and we believe this is being caused by micro-bursts (historical logs don't show pattern of over-utilization). The only drop...
Hi, I have a problem configuring ASA with 2 ISP. Both providers are over pppoe , one of it is with static address. My goal is to set the VPN traffic through internet with static address and all other traffic over the other ISP which has dynamic add...
Hi All,i wanted to know if i can and when i will be able to run the nexus 7000 as a Fully MPLS PE router (L2VPN, L3VPN etc..) ?the interfeces need to be 10Gbps so i need to use the 8 ports & the 32 ports M1 modules.thanks,Avi.
Resolved! Extended ACL - Quick one
I feel like i'm going mad here. I'm trying to create an ACL to place on VTY interfaces but my permit tcp 172.16.0.0 0.240.255.255 any eq 22 command is getting changed to permit tcp 172.0.0.0 0.240.255.255 any eq 22 once committed! It's changing the...
I have a Cisco 867VAE-W I was hoping someone would be able to look at my current config and help me to get NAT from outside my network to ip cctv cameras and remoted desktop functionality to work. I just can seem to get it to work. I have internet ac...
Hi Experts, I am looking for some assistance in how to connect a remote site, my boss had a service provider provide a DIA (Dedicated Internet Access) and the provider has provided a /29 address. I need to connect this site to our HQ router using so...
What are some of the new features in the new Catalyst 9000?
What is the difference between Catalyst 9300, 9400 and 9500?
Resolved! 3750 ignoring static route over metro e
The Cisco 3750 is ignoring a static route I have set. I have to be missing something small but can't see it. I am trying to tracert 172.20.2.5 it should go to 10.2.1.2 but instead is going to 10.3.1.2 which is a completely different datacenter. Bello...
Resolved! AWS <> Cisco IPSec configuration
Hi, I have a few IPSec tunnels between my Cisco router and my Amazon AWS VPCs (using the AWS VPC VPN functionality). I have always just downloaded the suggested configuration from the AWS VPN for Cisco and modified it for my router. I am no Cisco exp...
What is Encrypted Traffic Analytics? Advantages and disadvantages ?
Hello !I am having trouble with my iBGP routes. I am really confused how to set it up properly. Can anyone tell me about the wrong configurations related to my topology ? (ISP-1 CORE and ISP-2 CORE are Route Reflectors) *** This topology should work...
I have a DMVPN that consists of roughly 2 dozen sites. I have a few endpoints that register their correct NBMA IP with the NHRP server but somehow that same endpoint shows a different/incorrect IP at the other endpoints. In the example below, 172....
