GOLD test on sup720

[Antonio_1_2]

Hi,

is it possible to run GOLD test on supervisor engine which is in ROMMON mode?

A supervisor 720 3BXL got stuck in rommon and I want to check if it has some hardware problems.

So I want to put it in some 6500/7600 chassis with already working sup 720 and run GOLD test on that problematic supervisor.

But when I do so I get this message on console:

Router#diagnostic start module 6 test

% No diagnostic test is available for Module 6

Router#sh module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAL09368YP0
  6    0  Supervisor-Other                       Unknown            Unknown

Mod MAC addresses                       Hw    Fw           Sw           Status
--- ---------------------------------- ------ ------------ ------------ -------
  5  0013.7f0a.e3ac to 0013.7f0a.e3af   4.3   8.1(3)       12.2(33)SRB7 Ok
  6  0000.0000.0000 to 0000.0000.0000   0.0   Unknown      Unknown      Unknown

Mod  Sub-Module                  Model              Serial       Hw     Status
---- --------------------------- ------------------ ----------- ------- -------
  5  Policy Feature Card 3       WS-F6K-PFC3BXL     SAL09368ZY8  1.6    Ok
  5  MSFC3 Daughterboard         WS-SUP720          SAL09347Y52  2.3    Ok

Mod  Online Diag Status
---- -------------------

  5  Pass
  6  Not Applicable

has anyone done this maybe?

Thanks,

A

[Leo Laohoo]

Generic Online Diagnostics on the Cisco Catalyst 6500 Series Switch

I would recommend that you console into the Supervisor card in slot 6 and reboot/reseat the card.  Post the entire bootup process as this may provide you with some clue.

Oh freak me!  This is a DUPLICATE POST! 

[Antonio_1_2]

Hi,

it's not a duplicate post :-)

This one is only in regard to GOLD test on supervisor that is in ROMMON mode.

I'm interested in this generaly because I have few different supervisors stucked in rommon mode for different reasons,

and I'm trying to find mechanism to diagnose if that is a hardware failure.

But it seems (I'm not sure yet ) that GOLD doesn't work on supervisors in ROMMON.

I attached the bootup process in the other post :-)

Thanks,

A.