Hello Guys,
I'm replacing 2811 router with ISR 4331 blew the Sh inv command for the ISR i have two T1 cards what's the right config for it
NAME: "Chassis", DESCR: "Cisco ISR4331 Chassis"
PID: ISR4331/K9 , VID: V02, SN: FLM2032W0K7
NAME: "Power Supply Module 0", DESCR: "250W AC Power Supply for Cisco ISR 4330"
PID: PWR-4330-AC , VID: V01, SN: DCA2026147V
NAME: "Fan Tray", DESCR: "Cisco ISR4330 Fan Assembly"
PID: ACS-4330-FANASSY , VID: , SN:
NAME: "module 0", DESCR: "Cisco ISR4331 Built-In NIM controller"
PID: ISR4331/K9 , VID: , SN:
NAME: "NIM subslot 0/1", DESCR: "NIM-1MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-1MFT-T1/E1 , VID: V03, SN: FOC20294645
NAME: "NIM subslot 0/2", DESCR: "NIM-2MFT-T1/E1 - T1/E1 Serial Module"
PID: NIM-2MFT-T1/E1 , VID: V03, SN: FOC20241LQD
NAME: "PVDM subslot 0/4", DESCR: "PVDM4-32 Voice DSP Module"
PID: PVDM4-32 , VID: V02, SN: FOC20294765
NAME: "NIM subslot 0/5", DESCR: "ISR SSD Module"
PID: ISR-SSD , VID: V01, SN: JAB092709EL
NAME: "subslot 0/5 disk0", DESCR: "harddisk"
PID: UBA2RZC200HCE1-FTC-SWD , VID: 5.2.4 , SN: 11001497142
NAME: "NIM subslot 0/0", DESCR: "Front Panel 3 ports Gigabitethernet Module"
PID: ISR4331-3x1GE , VID: V01, SN: JAB092709EL
NAME: "module 1", DESCR: "Cisco ISR4331 Built-In SM controller"
PID: ISR4331/K9 , VID: , SN:
NAME: "module R0", DESCR: "Cisco ISR4331 Route Processor"
PID: ISR4331/K9 , VID: V02, SN: FDO202919GG
NAME: "module F0", DESCR: "Cisco ISR4331 Forwarding Processor"
