How do i Enable traffic shaping for inbound traffic on an interface?

[jimjames1]

traffic-shape rate bit-rate [burst-size

[excess-burst-size]] command only Enable traffic shaping for outbound traffic on an interface. How do i Enable traffic shaping for inbound traffic on an interface?

Jimjames

[leonvd79]

Hello Jim,

The answer is that you can't. Shaping is supported in outbound direction only.

What you can do is police inbound traffic.

This can be accomplished with either MQC or CAR.

Please use the documentation:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hqos_c/part20/index.htm

HTH

Leon

* Please rate posts