How to access another VLAN via my gateway to gateway connection
just wondering if anyone wiser than me can help. I have setup my gateway to gateway connection ok and I can access each side.
in the office I have now created two more VLAN networks on the RV320
I am trying to set it up so that the remote site can access all the networks (more for Remote Desktop to the servers)
i can see in the Gw to Gw setup, the RV320 asks for a subnet of each site and I can’t seem to add the new networks to this section. I have also read about using the Advanced Routing option. The VLAN are created and have enable inter VLAN access. When I am in the office I can access all the networks but not over the GW to GW connection. Can anyone help
Re: How to access another VLAN via my gateway to gateway connection
With any VPN setup you will typically require an ACL which is used to identify "interesting" traffic (the encryption domain) destined for the remote end which will be sent via the VPN.
Looking at the RV320 configure guides it would appear that you can only define a single subnet in this ACL. The issue you have is the 192.168.2.0 subnet lies between 192.168.1.0 and 192.168.10.0 and 192.168.20.0.
Due to this limitation you need to ensure each site is allocated a contiguous address block (this would be good practice TBH) ,eg:
Hello, We are working on a spare switch (with 12 fibre modules), which needs to be used as the failover switch in our company data centre. Cisco switch model : WS-C3750-12S(PowerPC405) Can you confirm the below : i. Does this switch su...
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...