I agree with Anton that it is not clear what the original poster is attempting to accomplish. If we had clarification about this we could provide better answers.
Having read through this post several times I have a guess at what is the goal. I am guessing that there are 2 routers, each with a serial WIC, and the goal is to combine the configurations on a single router with 2 serial WICs. Since each of the routers uses a single FastEthernet and a single serial interface it should be possible to combine the interface configurations pretty reliably. It might look something like this:
interface FastEthernet0/0
description LAN ElPais
ip address 192.100.10.2 255.255.255.0
duplex auto
speed auto
!
interface FastEthernet0/1
description Internet
ip address 186.24.0.113 255.255.255.248
duplex auto
speed auto
!
interface Serial0/0/0
no ip address
encapsulation frame-relay IETF
frame-relay lmi-type cisco
interface Serial0/0/0.1 point-to-point
description Wan_GlobalMix
ip address 10.1.7.1 255.255.255.252
frame-relay interface-dlci 20
!
interface Serial0/0/0.2 point-to-point
ip address 10.1.2.1 255.255.255.0
frame-relay interface-dlci 21
!
interface Serial0/0/0.3 point-to-point
ip address 10.1.0.1 255.255.255.252
frame-relay interface-dlci 22
!
interface Serial0/0/0.4 point-to-point
ip address 10.1.6.1 255.255.255.252
frame-relay interface-dlci 23
!
interface Serial0/0/0.5 point-to-point
ip address 10.1.3.1 255.255.255.252
frame-relay interface-dlci 24
!
!
interface Serial0/1/0
ip address 10.18.116.166 255.255.255.252
encapsulation frame-relay IETF
frame-relay interface-dlci 16
frame-relay lmi-type cisco
!
there are some other parts of the config in which we can make some assumptions about what the combined config should have:
- one router has name servers configured and one does not. so the resulting config should probably have
ip name-server 200.35.65.3
ip name-server 200.35.65.4
- one router runs EIGRP and one does not. so perhaps the resulting config should run EIGRP but only activate routing on some of the interfaces.
and there are some questions that we do not have enough information to resolve them in the resulting config. In particular both routers have a static default route. Which of the static default routes should be used in the combined config?
HTH
Rick
HTH
Rick
