How to install/config T1 module on 3745?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2005 11:12 AM - edited 03-03-2019 10:04 AM
I have a T1 from a Harris Intraplex multiplexer that I need to route over a high speed wireless link (2Gps). This link has a 3745(w dual GBIC's) on each side.
What can I use to integrate this T1 into the router and how to I config it to send the T1 traffic to the other side?
I was looking at the NM-HDV2-2T1/E1 module but I am not sure if this is what I need.
I am running IOS 12.2(8)T.
I have not made any purchases yet so I am open to any ideas.
Thanks
Mike
- Labels:
-
WAN
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2005 12:51 PM
Each T1 module provides up to 24 virtual channels per T1 port. Each channel can be configured individually as a serial interface.
CT1/PRI and CT1/PRI-CSU modules receive and transmit data bidirectionally, at the T1 rate of 1.544 Mbps.
