How to ping all interface ATM within the POP

[andrea.cipolla11]

Hello,

 I would like to ping all interfaces on the POP Cisco. What is the command that from this output?

Interface	VPI	VCI	status	ping atm	rtt ping atm
2/0.131	13	110	up	(500/500)	1/1/276 ms
2/0.129	13	125	up	(500/500)	1/4/296 ms
2/0.900	13	139	up	(500/500)	1/1/16 ms
2/0.183	16	118	up	(484/500)	1/18/76 ms
2/0.180	16	133	up	(482/500)	1/20/288 ms
2/0.213	16	135	up	(480/500)	1/20/296 ms
2/0.243	16	136	up	(483/500)	1/20/320 ms
2/0.212	16	137	up	(477/500)	1/24/312 ms
2/0.248	16	138	up	(487/500)	1/24/352 ms
2/0.148	16	150	up	(481/500)	1/20/336 ms
2/0.621	16	151	up	(485/500)	1/19/308 ms
2/0.204	16	152	up	(489/500)	1/17/112 ms
2/0.204	16	153	up	(479/500)	1/16/276 ms
2/0.215	16	154	up	(486/500)	1/17/80 ms
2/0.214	16	157	up	(488/500)	1/27/320 ms
2/0.132	16	163	up	(485/500)	1/16/308 ms
2/0.947	16	164	up	(487/500)	1/16/80 ms
2/0.162	16	165	up	(490/500)	1/20/320 ms
2/0.909	16	166	up	(486/500)	1/17/276 ms
2/0.198	200	48	up	(500/500)	1/1/36 ms
2/0.229	200	62	up	(500/500)	1/1/8 ms
2/0.945	200	69	up	(500/500)	1/1/20 ms
2/0.912	200	76	up	(500/500)	1/1/22 ms

[Mark Malone]

Hi you would need to build a TCL script and add all the ip addresses to it to ping all interfaces at once ,

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ios_tcl/configuration/12-4t/ios-tcl-12-4t-book/nm-script-tcl.html

[andrea.cipolla11]

Thanks for your support,

but can you help me to create a tcl script to ping all ip.
Do you have a tcl script ready ?

Thank and good job!

[Mark Malone]

Hey

Here is an example of what to do , you will need to replace the ip address with your own ips obviously , you change how many pings and the source with this script

First enter tclsh in priv mode then use the script below as it is in bold but change the ips , you can have as many as you want , tclquit to break out of router script mode

RouterC1DE44(tcl)#foreach test {
+>172.20.15.251
+>172.20.19.251
+>172.20.23.251
+>172.20.39.249
+>} {ping $test re 3 time 1 source vlan1226}

Type escape sequence to abort.
Sending 3, 100-byte ICMP Echos to 172.20.15.251, timeout is 1 seconds:
Packet sent with a source address of 172.20.226.118
!!!
Success rate is 100 percent (3/3), round-trip min/avg/max = 1/3/9 ms
Type escape sequence to abort.
Sending 3, 100-byte ICMP Echos to 172.20.19.251, timeout is 1 seconds:
Packet sent with a source address of 172.20.226.118
!!!
Success rate is 100 percent (3/3), round-trip min/avg/max = 1/1/1 ms
Type escape sequence to abort.
Sending 3, 100-byte ICMP Echos to 172.20.23.251, timeout is 1 seconds:
Packet sent with a source address of 172.20.226.118
!!!
Success rate is 100 percent (3/3), round-trip min/avg/max = 1/1/1 ms
Type escape sequence to abort.
Sending 3, 100-byte ICMP Echos to 172.20.39.249, timeout is 1 seconds:
Packet sent with a source address of 172.20.226.118
!!!
Success rate is 100 percent (3/3), round-trip min/avg/max = 1/1/1 ms
xco-d110nis01(tcl)#

[andrea.cipolla11]

Perfect, thanks you

but how do this command to script:

ping atm interface atm 1/0.25 Vp Vc seg-loopback

[Mark Malone]

Its an ip based scripting command its not possible to use the script like that

you would have to have the loopback ip address first and add it to the script enter tcl section of IOS and then run it

This is not a Cisco command its a programming language TCL that exists inside most Cisco devices that Cisco allows to be used in their IOS.

[andrea.cipolla11]

Ok could you explain me how to do on  the router?

Thanks

[Mark Malone]

If your still not sure you can post the ips and I will put them in the script for you

[andrea.cipolla11]

This is my ip ping:

10.251.12.126
172.31.20.218
10.251.43.178
172.31.250.142
10.251.9.162
172.16.103.182
10.251.45.38
10.251.9.214
10.251.22.238
10.251.12.38
10.160.9.146
10.251.9.118

[Mark Malone]

Change your source below that's highlighted to something on your router looback or another ip interface ,then copy this exactly into your router in privileged mode and then hit return that's it

tclsh
foreach test {
10.251.12.126
172.31.20.218
10.251.43.178
172.31.250.142
10.251.9.162
172.16.103.182
10.251.45.38
10.251.9.214
10.251.22.238
10.251.12.38
10.160.9.146
10.251.9.118
+>} {ping $test re 4 time 1 source vlan1226}

[andrea.cipolla11]

Thanks you, you are my good friead ahahahha 

Goodbye and good job