How to reset default factory command on ASA ,Router and Switch

[rechard_david]

Dear All,

I would like to ask you about how to reset default factory on ASA,Router and Switch ( i mean it similar wr erase but if we do command wr erase all the command is gone, so i would like to original command on product.

Best Regards,

Rechard

[mmacdonald70]

The only way to reset the ASA to factory defaults is with the "wr era" command or the "clear configure" command.

If these commands are not available due to a password issue (ie can't remember the enable password) you will need to reset the passwords:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1058131

[hobbe]

ASA

conf t

configure factory-default

Router: I dont know if there is such a command.

might be depending on model of router and software version.

so wr er and then reload is the closest I know off

Switch:

I do not know of such a command, might exist depending on model and software version

so wr er and then do a reload is the closest I know of.

Good luck

HTH

[ngonzales]

Hello, on a Cisco ASA from enable mode:

(config)# configure factory-default

Enter and there you go!

[paul driver]

Hello

ASA
conf t

configure factory-default

reload save-config noconfirm

Switch
write erase
delete flash:vlan.dat

reload