Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Good morning,We are upgrading our old environment (C2800) to the new Cisco 4000 series routers. We use one router as an bridge from multiple serial interfaces to an Ethernet interface, see attached file.  Now we are encountering an problem that the b...

BartvK by Level 1
  • 2334 Views
  • 6 replies
  • 0 Helpful votes

Hi Team,   ISR 4331 mention that it has "3 - Total onboard WAN or LAN 10/100/1000 ports" and same it says "2 - RJ-45-based ports".   So if I need to have 3x1GE ports can we select ISR 4331 instead of 4351. My requirement is 3x1GE and 2xSFP

prashanma by Level 1
  • 884 Views
  • 4 replies
  • 0 Helpful votes

%PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map "XXX " has unsupported options for Policy-Based Routing. It has been removed from interface, if applied.   Hi All ,    Need your advice to fix the error given above on my new device -3850     My site has Le...

Vinodh KC by Level 1
  • 3165 Views
  • 9 replies
  • 0 Helpful votes

Hi there, Thanks for reading.   I have a pair of routers with IPSEC tunnels configured.  The routers can ping each other's public IPs.  There are crypto isakmp keys with appropriate peer-router IP addresses.  There are spot-on matching crypto isakmp ...

Bob Greer by Level 4
  • 22333 Views
  • 11 replies
  • 0 Helpful votes

Hi Guys,I need some advise here, we have a 1gb circuit between site A and site B (500km distance) which we are told is underperforming. Through iPerf testing I have found that for a standard TCP test with no extra parameters, we only hit a maximum of...

nzChris by Level 1
  • 5464 Views
  • 6 replies
  • 0 Helpful votes

Hello, I've got an email from our ISP, that our router is in danger... They found that the router has SNMP port opened. After that, I scanned our router I found more opened ports: UDP 161, 123, 500 (it is OK, the router does S2S). Could you please ch...

Exonix by Level 1
  • 2046 Views
  • 12 replies
  • 0 Helpful votes

Hello, I have a Cisco 3725 router connected to a Cisco SF500 switch, also connected to a SF500 switch (trunked)When I try to ping 10.1.2.5 from the router, it fails. When I debug it stated:R1#debug ip packetIP packet debugging is onR1#ping 10.1.2.*Ma...

geoffwynn by Level 1
  • 1916 Views
  • 11 replies
  • 0 Helpful votes

Hi team,I have configured SSH on my 2911 router. Verified all configurations but unable to take SSH from putty. Want to know if any mistaken done from my end. Please help me. Connection Version Mode Encryption Hmac State0 2.0 IN aes256-cbc hmac-sha1 ...