http://pastebin.com/1dMn7XYg
This is the code I was trying to use.
I am trying to connect SW 1 to R1 and R2 and SW 2 to R1 and R2.
My topology is for testing, I have a pc connect to SW3 that is connected to SW 1 and SW 2.
When I get th is figured out, im going to have 2 interfaces on Computer 1, that connect to two seperate switches.
I can't seem to get a ping to work, and a failover.
Cany any one give me a hand with this?
R1
enable
conf t
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
bridge 2 protocol ieee
bridge 2 route ip
track 1 interface fa0/0 ip routing
int e1/0
no ip address
bridge-group 1
no shutdown
int e1/1
no ip address
bridge-group 1
no shutdown
int e1/2
no ip address
bridge-group 2
no shutdown
int e1/3
no ip address
bridge-group 2
no shutdown
int BVI2
no shutdown
ip address 10.10.2.2 255.255.255.0
standby 1 ip 10.10.2.1
standby 1 priority 100
standby 1 preempt
standby 1 track 1
int BVI1
no shutdown
ip address 10.10.1.2 255.255.255.0
standby 2 ip 10.10.1.1
standby 2 priority 100
standby 2 preempt
standby 2 track 1
R2
enable
conf t
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
bridge 2 protocol ieee
bridge 2 route ip
track 1 interface fa0/0 ip routing
int e1/0
no ip address
bridge-group 1
no shutdown
int e1/1
no ip address
bridge-group 1
no shutdown
int e1/2
no ip address
bridge-group 2
no shutdown
int e1/3
no ip address
bridge-group 2
no shutdown
int BVI2
no shutdown
ip address 10.10.2.3 255.255.255.0
standby 1 ip 10.10.2.1
standby 1 priority 105
standby 1 preempt
standby 1 track 1
int BVI1
no shutdown
ip address 10.10.1.3 255.255.255.0
standby 2 ip 10.10.1.1
standby 2 priority 105
standby 2 preempt
standby 2 track 1
Topology is here
http://img849.imageshack.us/img849/599/examplede.png
I am trying to get HSRP to work with two switches.
I am trying to bridge both interfaces on each router into one virtual interface and then configure HRSP on the virtual interface.