08-05-2014 04:24 AM - edited 03-04-2019 11:29 PM
Dear Techies,
One of our customer is currently running the following IOS version;
c2900-universalk9-mz.SPA.151-4.M3.bin
Please advise me on the following concerns,
Q1. Please let me know if we install the “HWIC-2T” rather than "HWIC-1T" module with current IOS version will there be any compatibility issues?
Q2. Please distinguish the technical capabilities of both Cisco HWIC-1T and HWIC-2T modules?
Regards,
Syed Farhan Ali
08-05-2014 03:43 PM
Q1. Please let me know if we install the “HWIC-2T” rather than "HWIC-1T" module with current IOS version will there be any compatibility issues?
Yes.
Q2. Please distinguish the technical capabilities of both Cisco HWIC-1T and HWIC-2T modules?
Look at what's highlighted above this line. Do you see the difference?
Go HERE for more information about the two.
08-05-2014 10:30 PM
Dear Leo,
Thanks for your response. Regarding Q1, can you please elaborate the compatibility issues and how we can overcome them.
Regards,
Syed Farhan Ali.
08-06-2014 01:58 AM
What compatibility issue are you referring to? Did you read the Data Sheet link I've posted?
08-06-2014 02:56 AM
I have read the datasheet. With respect to your last post you mentioned a "Yes" in response to the following question:
Q1. Please let me know if we install the “HWIC-2T” rather than "HWIC-1T" module with current IOS version will there be any compatibility issues?
Therefore I was asking which compatibility issue might come and how can we overcome it.
08-06-2014 03:38 PM
I really don't understand about your "compatibility issue". HWIC-1T and HWIC-2T behaves the same way. The only difference is one port vs two ports. That's it.
So I really don't understand what your concern is.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide