Routing

My network is allocated a total of 16 Public IP addresses, and my internet interface routes these to an ASA firewall. I would like to limit the traffic entering / exiting the public interface by the IP address it is destined to: For example:  2.2....

Hi, I looking some router 28xx series, with capability for NATing IP traffic from 2000-3000 clients, I think to take 2U size (2821 or 2851), I have 2811, please help, I do not know where to find this informacion...  :)

The above diagram shows the setup of my network.We have 2 site running service to provide content for our customer. Both ISP aggregate our ASN 4000 so that which client can find which ever AS path is closer to them.Question is that if our iBGP link i...

Hello, I have a couple of questions as im a complete rookie on this.I have an 876 DSL router with ip address 10.10.10.1 and i need to allow all trafic to asa 5505 with ip address 192.168.1.1  which is also my default gateway. I am quite confused with...

Hi,I am doing conditional default route advertisement in ISIS on IOS XR as follows: route-policy PL-DEFAULT-ROUTE-CONDITION  if rib-has-route in (172.16.10.1/32, 172.16.10.2/32) then    set level level-1  endifend-policy!router isis core address-fami...

Hello, I am a Cisco new guy so sorry for the new guy type question. I am setting up a 1921 for small office with dual WAN from different ISPs, there is already an ASA5505 doing the firewall and NAT duties, the router is mostly for load balancing with...

Good Day,I am trying to setup routing between two different ISP due to our division was sold to another company.  So right now I am running two different networks on the router a 131.199.118.0/24 which is being routed via to our corporate headquaters...

Guys,We are planning to install a cisco ASA on an ezvpn environment and at some of the locations building security may not great. In order to prevent access if somebody takes our ASA and connects it somewhere else we would like to lock down the switc...

Hi all! We got ASR901. I tried to configure xconnects through intervace vlan, but without success. As I red in config guide, this scheme is not supported now. Supported is only xconnect termination on service instanse. Hwo knows will be supported xco...

Let's say I have CEs connected to 2 different Networks (Network A and Network B), Network A and B are not connected to each others as far as i know.The CEs connect to each network using ebgp.Now is it possible to use null0 to advertise /24 to Network...

I am hoping to get some direction on a routing design. I have a data center connected to two collocations via DWDM. The three locations are within in the same EIGRP AS 10, EIGRP is the only routing protocol running between the data center and the two...