cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
562
Views
0
Helpful
0
Replies

IGMP Report issue destination is 0.0.0.0

vincentbesson
Level 1
Level 1

Hi Expert, 

I have a Cisco Router and i want to enable IPTV multicast stream from interface VLAN 100. The aim is to replace my ISP box by a cisco router, 

I have identified an issue 

With Wireshark I have a trace with the ISP Box and we can see IGMP Report (Join) and IGMP Leave sent to the WAN with right destination address 232.X.X.X.

When i use my router with an igmp proxy i have IGMP Report with destination to 0.0.0.0 and no leave message

Please have a look at the attached screen shot

Hereafter my cisco igmp proxy config 

interface Loopback0

 ip address 192.168.2.1 255.255.255.0

 ip pim dense-mode

 ip igmp helper-address udl GigabitEthernet0/0.100

 ip igmp proxy-service

!

interface GigabitEthernet0/0.100

 description SUBIF BYTEL IPTV VOIP PFS

 encapsulation dot1Q 100

 ip dhcp client client-id hex 0037B755E368

 ip dhcp client class-id byteliad_private

 ip address dhcp

 ip pim sparse-mode

 ip nat outside

 no ip virtual-reassembly in

 ip igmp unidirectional-link

 no cdp enable

!

interface GigabitEthernet0/1

 description IF LOCAL NETWORK 1

 ip address 192.168.1.1 255.255.255.0

 ip pim sparse-mode

 ip nat inside

 ip virtual-reassembly in

 ip policy route-map ISPSelect

 ip igmp mroute-proxy Loopback0

 duplex auto

 speed auto

!

Can you please help to solve this blocking issue.

Thanks 

Vincent 

0 Replies 0
Review Cisco Networking for a $25 gift card