Integrated Routing and Bridging (IRB)

[lionel valero]

Hello,

I cannot assign a bridge group to a subinterface :

interface GigabitEthernet0/1/3

no ip address

negotiation auto

!

interface GigabitEthernet0/1/3.3

encapsulation dot1Q 3 native

*** bridge-group 3 is not recognized by IOS XE Version 15.1(3)S1

!

interface GigabitEthernet0/1/3.228

encapsulation dot1Q 228

*** bridge-group 228 is not recognized by IOS XE

!

interface BVI3

ip address x.x.3.1 255.255.255.0

!

interface BVI228

ip address x.x.228.1 255.255.252.0

!

bridge 3 protocol ieee

bridge 3 route ip

bridge 228 protocol ieee

bridge 228 route ip

It appears that the bridge-group command is not available.

Regards

[Reza Sharifi]

Hi,

Have you tried the command under the interface and not sub-interface?

interface GigabitEthernet0/1/3

no ip address

negotiation auto

bridge-group 3

HTH

[lionel valero]

Hello,

yes i tried that because i read on a post that bridge-group should be set on the interface and sub-interface as well, but even on the interface the command is not available.

Regards.

[lionel valero]

Hello,

Finally I was told that the "bridge-group" command in not yet available on IOS XE, and will be implemented in the next release. It is quite surprising.

Regards.