cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

8635
Views
5
Helpful
19
Replies
Highlighted
VIP Mentor

Re: Interface down/down issue.

Glad to know that it was resolved, is that resolved after defaul the interface. ?

 

if the interface up, can you post show run interface and show interface gi x/x

BB
*** Rate All Helpful Responses ***
Highlighted
Beginner

Re: Interface down/down issue.

Take a look at the speed.

 

GigabitEthernet0/2 is up, line protocol is up
Hardware is CN Gigabit Ethernet, address is 1c6a.7a17.5662 (bia 1c6a.7a17.5662)
Internet address is 45.235.173.164/27
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full Duplex, 100Mbps, media type is RJ45

Highlighted
VIP Mentor

Re: Interface down/down issue.

I was about to refer this document from Rukus :

 

http://docs.ruckuswireless.com/fastiron/08.0.70/fastiron-08070-managementguide/GUID-A3EDF349-50D4-4003-B99D-F3C32D74E9F5.html

 

Thank you and good to know.

BB
*** Rate All Helpful Responses ***
Highlighted
Beginner

Re: Interface down/down issue.

I too have same kindly of issue, we are having tow internet connection both are getting DHCP IP. When the internet goes down Interface status& Protocol showing up always. And ACL configured to restrict the ping to internet. So its very difficulty to address the issue. Kindly suggest. 

Highlighted
Hall of Fame Guru

Re: Interface down/down issue.

You describe a problem but give us very little detail about it to help us identify the issue. As a start can you be more specific about what you mean when you say the Internet goes down? 

 

If you have two Internet interfaces are you using them both actively at the same time (load sharing) or are you using one as primary and the other as backup? Are you running a dynamic routing protocol on these interfaces or are you using static routing?

HTH

Rick