Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm trying to configure a site to site VPN between Cisco and Allied Telesis, but I don't even know if it is possible.When I do "sh crypto isakmp sa" it says: dst src state conn-id status2.2.2.2 1.1.1.1 MM_NO_STATE 0 ...
Hi everyone. I want to do some tests on a old version of CUCM, my Active Version is 11.5.1.10000-6, that version has been working for a while now (7 or 8 monts) and have a lot of configuration, the Inactive Version is 9.1.2.10000-28. If I perform a s...
Hi everyone, the VPN works, is Active-Up I can ping from the Branch to the HQ, but I can't do it from the HQ to the Branch.Please find attached the sh run of both Routers.
Hi everyone.
I made a site to site VPN between cisco routers. When I do sh crypto session I get an UP-IDLE status in both routers . Only headquarter is configured with Static Public IP address, the other router has a Dynamic Public IP address. In s...
Hi everyone! I have some issues with SIP Trunk calls.My scheme is the following: SIP PSTN --> CUBE --> SIP Trunk to CUCM We just change our headquarters location and we brought or equipment with us, previously the SIP Trunk worked and here the proble...
Thank you for your help,I want to go back to an older version because I have a bunch of 8941 phones that are trying to upgrade to 9.4(2)SR2 but first, they need to downgrade to 9.3(4) in order to work. The problem is that CUCM 11.5 does not support t...
Hi, thanks for your answer.
I did the specified changes but still UP-IDLE.
Please find attached the sh's.
There's nothing on ipsec sa on headquarter router.
I have a question.
There's an extra ip route that I need to configure?
It was a speed issue.I did not check the ruckus parameters because I do not have access to them, it is part of the network of the building where my office is located and my task was to configure an internal router with output to that Ruckus switch. G...
