Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
836
Views
5
Helpful
1
Replies

Internal and External DNS servers configuration in 2811router

AL1119
Level 1
Level 1

‎11-28-2020 01:09 PM

Hello,

 

I am running PacketTracerv7.3 and am trying to configure my CISCO 2811 router to check multiple DNS servers and have tried both commands:

     ip name-server server-address1 server-address2 

 

    ip dhcp pool dhcp_pool_name

    dns-server server-address1 server-address2 

However an 'Invalid input detected' error is shown at the start of the second server_address.

Is there any other way to set the router to check both DNS servers please? 

 

Labels:
0 Helpful
1 Reply 1

paul driver
VIP
VIP

‎11-28-2020 01:34 PM - edited ‎11-28-2020 01:34 PM

Hello
Must be PT it is flakey it and it does has limited functionality for those commands should work on real hardware.


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Customers Also Viewed These Support Documents