ā11-25-2013 07:39 PM - edited ā03-04-2019 09:41 PM
Hi
Would want to inside source NAT an IP address which is not direclty attached to the NAT inside interface ,,,it is a hop away from the inside interface...Appreciate pointers!
Solved! Go to Solution.
ā11-25-2013 08:32 PM
Just configure as if the host were in the same subnet as one of the interfaces. Ip nat inside on the interface closest to the host.
Sent from Cisco Technical Support iPad App
ā11-25-2013 11:35 PM
Hi,
2points:
1) permit this subnet in your NAT ACL
2) make sure the router doing NAT has a route for this subnet.
Regards
Alain
Don't forget to rate helpful posts.
ā11-25-2013 08:32 PM
Just configure as if the host were in the same subnet as one of the interfaces. Ip nat inside on the interface closest to the host.
Sent from Cisco Technical Support iPad App
ā11-25-2013 11:35 PM
Hi,
2points:
1) permit this subnet in your NAT ACL
2) make sure the router doing NAT has a route for this subnet.
Regards
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide