IOS XE 3.10 with just one physical interface being used ...all hosts in public range and when they need to reach some other network ..they need to be able trigger a IPSEC GRE tunnel through that one physical imterface thats on the same network as t...
HiWould want to inside source NAT an IP address which is not direclty attached to the NAT inside interface ,,,it is a hop away from the inside interface...Appreciate pointers!
Been few years outside the routing /switching world...is there any config out there that supports NO nat between 2 IPSeC IOS endpoints...ie traffic goes untranslated from one side LAn to other ...if we avoid NAT statements ...will this be enough j...
Are there any Standard operating procedures/guidance for troublehshooting /monitoring/performance recommendations for UCS standalone servers especially for those in Virtualized environmentsAppreciate
yes this is a IOS to IOS router ...and if im reading right ...if i declare isamp policy, Ipsec policy, cryptomap with crypt ACL and bind the crypto to interface it should be enough ..by default in absence of NAT statements on the interfaces and AC...
I guess i did oversimplify this i had already accounted for a phase 1 isakmp and phase 2 ipsec and crypto map with appropriate ACL....i guess my question was how do i ensure traffic entering the tunnel is not NATTed ....ie the far side of tunnel s...
Appreciate !...i did however think ipblocking for standalone was more as lockout for bruteforce ...and yes the manual is ambivalent..maybe it talks about UCSM based management pool access ...which is not the case for standalone!so yes really left won...
We need to access the CIMC over internet for some remote servers (like we did DRAC,ILO in past) and they are in standalone mode ...no UCSM hook in...need to lockdown/harden access of CIMC as far as possible especially web...saw some ip blocking feat...