cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
533
Views
0
Helpful
1
Replies

IP SLA design

The_guroo_2
Level 2
Level 2

Hi

We have two data centres  A and B

Both are same in design

Datacentre A:

WAN router is connected to ------firewall-------firewall has many DMZ switches----------firewall internal interface is connected to core switch.....the core switch is connected to datacentre B via fibre and running OSPF (same vlan spanned)

Datacentre B:

Same as datacentre A

Design for high availability:

In datacentre A I am thinking that i would add a default static route pointing towards firewall internal interface on firewall.

I will add IP SLA and will ping the interface of provider router on WAN as soon as it fails, IP SLA will install a static route towards the second daatcentre internal firewall interface.

Is this a good design????

Do i have to add any Static routing on datacentre B???

this is tarffic going out for in traffic we will use BGP with service provider

please advise

1 Reply 1

Julio Carvajal
VIP Alumni
VIP Alumni

Hello,

A draw could be way better for us to provide you a better design.

I would not want to provide any response yet until I have a better description of the network setup.

Then I will let you know where to set the SLA and how to do it if you allow me

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: