ISDN BRI Interface ?????

[afzaalq007]

Hi

I want to test my bri interface of Cisco 2500 router, whether its ok or not ??

I have no shut the interface and it show

outer#sh ip int brief

Interface IP-Address OK? Method Status Protocol

BRI0 unassigned YES unset up up

BRI0:1 unassigned YES unset down down

BRI0:2 unassigned YES unset down down

Ethernet0 unassigned YES unset up down

Serial0 unassigned YES unset down down

Serial1 unassigned YES unset down down

Thanks

[desai.jaideep]

Hi

To test a port, you need to have a BRI line with you.

Which cisco router is that?I believe that since u have a 2500 series, you should have an S/T interface, in which you need to connect external NT-1 device.

=====----

For more configuration, you need to refer to following link.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c/fnsprt3/dcdbri.htm

Pls revert back if u have any problem.

Regards

JD