Routing

I'm setting up multicast in my network.I've got 2 routers candidates rp for 2 different ranges of IPsR2:ip pim send-rp-announce scope 16 group-list 99access-list 99 permit 225.0.0.0 0.255.255.255-R5:Router(config)#ip pim send-rp-announce scope 16 gro...

Hi,I have some problem in DNS server which is located in Banaglore. Now, I want to forward all DNS request from my router connected to that DNS server to My Hyd/Chennai DNS server so that i don't need to ask customer to change DNS and their request g...

HiI want to test my bri interface of Cisco 2500 router, whether its ok or not ??I have no shut the interface and it show outer#sh ip int briefInterface IP-Address OK? Method Status ProtocolBRI0 unass...

guys,i did a back-to-back ftp test which connected directly to fastethernet at each routers. the problem is, we detected that the upload speed slower than download speed. but, based on theory, both speed should be similar.so does anyone know what the...

Hi,Can anybody suggest a great university for master in telecommunication & networking?In Euro or Japan. If it have CCIE programme would be more great. Thanks.

Dear all,We currently have a single connection out to our company WAN, which we currently route traffic through which is destined to the Internet (as well as systems hosted within the organisationl WAN).My question is this:- If we were to install a s...

HiI have seen my router logs , i found this debug messages." Di1 DDR: Cannot place call, no dialer string set " I think, this cause from ospf hello interval . how can i prevent router to sent hello message on dialer ( when it's not used for backup)th...

I am currently using two WIC-1T in 2600, one is connected for E1 and other is serving 512Kb circuit and they are working fine. Now I upgraded to have WIC-2T in slot W0 for E1 and 512Kb circuit and WIC-1T in slot W1 for connecting another router back-...

Can I know where can I get the CATOS and IOS equivalent CLI commands?For example, In IOS: show ip interface briefIn CATOS: ????

Hi,Can I know how does OSPF protocol select the routing link by, metric, cost and priority?For example, does it mean that the higher WAN link metric value is the preferred link?

Hi,Is it possible to configure ISDN as a backup form both ends of a leased line.For Example Router A , to router B a leased line is established and is working ok. Router A has a ISDN-PRI connection and Router B has BRI connection. Normally when lin...

hi everybodyjust wondering if this can be done.Using the DB 60 port off of a 2501 or any 25xx for that matter for anEthernet port (10baseT or 100baseT) with the help ofsome type of adapter/converter.thanks for your help

I am trying to connect 2500 and 2600 routers back to back. I have WIC-2T and WIC-1T in 2600. IS it possible to connect WIC-2T with CAB-SS-V35FC DCE and CAB-V35MT on 2500 end.Please guide.