cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
817
Views
0
Helpful
1
Replies
Beginner

L2TPv3 pseudowire + BVI

Hello,

  Is there a way or simple solution to terminate a bunch of "plain" L2TPv3 pseudowires to a BVI, to have a sort of VPLS? (VPLS/MPLS is not an option in my setup).

My deal is to have a distributed L2 architecture (I have a protocol that works only on L2), and it must traverse a non-ethernet IP based network. (traffic is quite low - max 1 mbps)

It can easily done with a simple linux box, terminating l2tpv3 tunnels to a bridge interface, but I would like to do that on a cisco device.

A very dirty solution can be to have a set of sub-interfaces (with xconnect) and a cable to another interface on the same router, having sub-interfaces terminated on a BVI.

Something like that:

GigaEthernet 0/0 is cabled to GigaEthernet 0/1

interface Giga 0/0.1301

  encap dot1q 1301

  xconnect 10.10.13.1 1301 pw-class pw1301

interface gig 0/0.1302

  encap dot1q 1302

  xconnect 10.10.13.2 1302 pw-class pw1302

interface gig 0/1.1301

  encap dot1q 1301

  bridge-group 1

interface gig 0/1.1302

  encap dot1q 1302

  bridge-group 1

bridge 1 protocol ieee

bridge 1 route ip

interface BVI 1

  ip address 192.168.1.254 255.255.255.0

Is there a simple way to accomplish that?

thanks in advance,

stefano

Everyone's tags (5)
1 REPLY 1
Beginner

I cannot implement this type

I cannot implement this type of configuration with a 3945 router...it's a shame...I really need this config for a site.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards