cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
792
Views
0
Helpful
2
Replies

layer 2 and layer 3 vpn

dannymcca
Level 1
Level 1

Hi,

i am trying to set up a vpn that will pass both layer 2 and layer 3 traffic.

i have 2 887VA routers and these communicate via adsl lines. They are currently passing layer 3 traffic without any issues and i have used an IPSEC-ISAKMP security.

It has been some years since i did my CCNA and am therefore very rusty and would appreciate as much help as you can give.

Many thanks

2 Replies 2

Jeff Van Houten
Level 5
Level 5

You might want to look at l2tp instead of IPSec.

Sent from Cisco Technical Support iPad App

i have looked for a sample l2tp configuration but most use pppoe whereas my connection is over adsl using ppoa.

i currently have a working vpn using ipsec/isakmp is there a simply way to enable this to use l2tp protocol?

my current config is attached.

thanks for your help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: