Routing

I have a 3560G that I cannot apply a policy route-map to one of the VLAN interfaces. I am running up to date software, c3560-ipservicesk9-mz.150-2.SE2 and it accepts the command, but does not show it in the sh run of the interface. I updated to this ...

Here is my topology. I would like to add redundancy to DMVPN Hub. So, planning to set up a secondary DMVPN hub at Data center 1. I would prefer having a simple set up. We are running DMVPN Phase 2.Few questions:Should I go with Dual Hub - Single DMVP...

Hi All, I've been getting errors from my CM RTMT:FW: [RTMT-ALERT-StandAloneCluster] SDLLinkOutOfServiceBased on the above alert this can be due to delay, jitter, packet loss...ect.We have QOS in place and other than the above alert no complaints from...

Hi all,I'm trying to copy a file from using copy https://user:pass@server/file flash: . Credentials are correct and I can download the file using http, but everytime I use https I get the following errordebug ip http allhttp_client_abort_request:http...

Hi, I searched a lot but couldnt find a clear document about connecting 2 G.SHDSL routers back to back.First of all I am not sure which type of cable (RJ11) is used for connecting two 878 routers.Does it have to be cross or straight cable.Is there an...

Friends,One of my Financial Software Development customer has a requirement of Public IP’sTo connect to his end customer, my customer requires 1:1 NAT for each user. Any repeated request from Same Public IP is not accepted by end customer device. Bec...

We have two main sites, site A and site B, that communicate via point to point WAN links using BGP. We have two routers, Site A (route1 and Router20 and Site B (Router1 and Router2) at each site with four differant AS numbers. We use OSPF as our IGRP...

Does anyone out there have a config for a 1760 to support AT&T's ADSL 6meg, I would like to compare it to what I have.Sent from Cisco Technical Support iPad App

Guys is it possible that a public IP can be automatically routed to another public ip.For example I have two routers A and B.router B has a LanB in 10.0.0.0 network and the public ips are in the x.x.x.0 for internet access.router A is located at a re...

Dear All,Am new to Nexus switching, i have a  Nexus box that i need to link with IBM servers with 10GB Network Cards.could somebody guide me on how to set up fiber channel on this machineJude.

Dear all ,I have a cisco box Nexus 5548 box i need to setup.what is the basic configuration i need to do so as to setup the following:1. Management interface2.Reduce the switch priority to join other switches in the network3.setup etherchannel etc