cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
554
Views
15
Helpful
5
Replies

Link aggregation or virtual IP

UCrypto
Beginner
Beginner

Dear all ,

I would like to know stupid question.I have the problem to integrate existing network and HA firewall.

please see below diagram and let me know can i conbine two routed interfac to one virtual IP ? it is not mean vrrp. i mean i want to run ether-channel or trunk or link aggregation to see single redundancy link.

Can i solve by using lacp ?

 

5 Replies 5

nazimkha
Enthusiast
Enthusiast
Need more information about the switches connecting firewall. For eg : If you are planning to connect a pair of Nexus you can use vPC to the firewall or if you have catalyst you can use VSS or stackwise virtual

Thank for help .I would like to know can i solve without using switches?.
May I know can I configure two router ports as a single virtual port.Eg L3
ether channel or route aggregation?

paul driver
VIP Expert VIP Expert
VIP Expert

Hello

What kind of fw HA pair are you wanting to use Make/Model?  - When a FW HA is created (say on a cisco ASA in a active/standby mode) the primary and secondary addressing is created on the one fw along with the specified LAN/Stateful failover links usually on the soon to be designated primary fw then when the physical connections are made the standby fw  will synchronize with he primary and a the HA is created, thus the same primary inside/outside address will be available on either physical fw so you really wouldn't need hrsp.

 

 

 

 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul