Link aggregation or virtual IP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2018 06:41 AM - edited 03-05-2019 11:00 AM
Dear all ,
I would like to know stupid question.I have the problem to integrate existing network and HA firewall.
please see below diagram and let me know can i conbine two routed interfac to one virtual IP ? it is not mean vrrp. i mean i want to run ether-channel or trunk or link aggregation to see single redundancy link.
Can i solve by using lacp ?
- Labels:
-
LAN Switching
-
Other Routers
-
vEdge Routers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2018 09:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2018 05:15 PM
May I know can I configure two router ports as a single virtual port.Eg L3
ether channel or route aggregation?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2018 06:38 PM
Hello
What kind of fw HA pair are you wanting to use Make/Model? - When a FW HA is created (say on a cisco ASA in a active/standby mode) the primary and secondary addressing is created on the one fw along with the specified LAN/Stateful failover links usually on the soon to be designated primary fw then when the physical connections are made the standby fw will synchronize with he primary and a the HA is created, thus the same primary inside/outside address will be available on either physical fw so you really wouldn't need hrsp.
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2018 05:43 PM
I have confuse in desing.If WAN link of R1 is down,branches can detect wan is down and so they swing their traffic to R2.But our VRRP didn't know R1 WAN is down or not.So R1 is still primary and return traffic is fail,correct ? And our FW cannot detect the WAN and FW still forward the all traffice to R1 and traffice is fail,correct ? how to solve this issue ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2018 06:11 PM
Hi,
I think this is a duplicate question. I just replied to your post with a suggestion as VRRP with IP SLA.
Regards,
Deepak Kumar
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
