cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
383
Views
0
Helpful
1
Replies

Load Balancing in CISCO 7600 Router

Hi Team,


Please find the below observations. Kindly help me to find a solution for the load balancing issue in CISCO 7600 Router. 


1. In MPLS Router, there are 5 STM-6 media and normally the traffic is sharing by all media.
2. In case of any one media goes down; the particular traffic is not sharing by remaining all media, instead only ISP-3 media utilization becomes high that time.
3. Our End using SUP32 (not supporting hierarchal service policies) card, But other End using ES20 card.
4. Both side interfaces are configured with OSPF cost value 2 for all media. OSPF configuration is Point to Point.
5. Pinging Destination IP with source IP and Packet Size 1600, we are getting following latency in all media.

Router 7606 ISP-1   4/5/60 ms
Router 7606 ISP-2   4/5/60 ms
Router 7606 ISP-3   4/7/24 ms
Router 7606 ISP-4   4/4/44 ms
Router 7606 ISP-5   4/4/28 ms

 

Thanks

ARUN RAJ S

1 Reply 1

Richard Burts
Hall of Fame
Hall of Fame

Duplicate post. See this thread for the active discussion

https://supportforums.cisco.com/discussion/12617971/load-balancing-router

 

HTH

 

Rick

HTH

Rick