Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

I am going to design a  two level Route Reflector architecture in order to get scaling and flexibility for the BGP updates coming for a large number of clients. I am not sure of the basic configuration iBGP and iBGP-RR necessarily for create the core...

Hi! I have a router with two E1 PRI, so I have a many mesage on the console like "%ISDN-6-CONNECT: Interface Serial0/0/0:17 is now connected to" and "%ISDN-6-DISCONNECT: Interface Serial0/0/1:6 disconnected from". This message make me problem with d...

paa by Level 1
  • 4908 Views
  • 6 replies
  • 0 Helpful votes

Hi,Have a working VSS with 2 x 4500X's - Testing failover on them, and notice when I disconnect the VSL link, the standby swich reboots - Is this expected behaviour? (dual-active scenario?)sw1-standby>*Mar 24 16:02:28.837: %VSLP-3-VSLP_LMP_FAIL_REASO...

hi expert, seeking your great advice on the below scenario:I work in small ISP and we provide internet over DSL and point to point internet as well.We have a cisco SCE in which we use to control customers bandwidth and monitoring. The thing we are fa...

Hello,I want to monitor my ISP modem, it is a Cisco EPC3010: http://www.cisco.com/c/dam/en/us/products/collateral/video/cable-modems-high-speed-data/7018339.pdfIn the documentation says that: Quote:Remote manageability using SNMP V1/V2 and V3I can ac...

hello,we have a ppp over atm link connected router with dialer 0 interface and virtual-access1 clone of it because of ppp connection.You can see the configuration below;interface Dialer0 description VAE_DSL_primary ip address negotiated ip mtu 1300 e...

ilkerkaya by Level 1
  • 503 Views
  • 4 replies
  • 0 Helpful votes

I am trying to work on a DMVPN solution. It has abut 10 spokes and 3 Hubs. Hub1 and Hub2 are located in the same location(Say SIngapore). Hub-3 is located at a different location(say USA).I am trying to achieve failover between the 3 Hubs. All the 3 ...

Dear all, I got a problem regarding encryption, and I am not sure how I should focus on the problem. I do not have that much of experience in the encryption world.I got a WAN network (sharing the same IP Address/bcast domain). There are 4 locations a...

lupobcn83 by Level 1
  • 532 Views
  • 4 replies
  • 0 Helpful votes

I have a LAB scenario to discuss with you if you can assist me to figure it out the correct IPs to uses.Environment: Site A (LAN 1) ==> Connected with a Switch (Running MS Server 2012 R2)Site B (LAN 2) ==> Connected with a Switch. (Running MS Server ...

amh4y0001 by Level 3
  • 1006 Views
  • 6 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card