LS1010 - Changing ISP

[cyberslee]

Hi All,

I am definitely over my head with LS1010.

Here is the situation and I am not at all familiar at all with the LS1010.

I have DS3 ATM circuit with Verizon and Verizon also was a ISP for my school. I am changing the ISP to another company and Verizon has mapped PVC from my school to the new ISP company. However, I have no idea how to change the information on the LS1010. I was told to change the following settings:

VCC

VCI

VPI

Can anyone help!!! I am supposed to do this on Friday!!!

Thanks!

[graemeporter]

Hi there,

I've never even seen these before. However, after a bit of digging on Cisco's website, I found this link which may help you:

http://www.cisco.com/en/US/products/hw/switches/ps1893/products_configuration_guide_book09186a00800f4ef4.html

Hope it's of use!

EDIT: Picking at this document further at least shows that the LightStream 1010 runs some version of IOS, so configuration shouldn't be too difficult.

Have you ever used a Cisco device previously? If so, can you access the device and do "show run" and paste the configuration here?

Kind regards,

Graeme

[cyberslee]

Thanks for the reply!

The link seems very helpful. Unfortunately with limited experience with Cisco product, it will be a challenge to understand the document and how to configure it.

Once again, thanks!