Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
4104
Views
0
Helpful
31
Replies

making an E1-FXS interface system for dial-up

ali6359
Level 1
Level 1

‎06-05-2019 12:50 PM - edited ‎09-07-2019 07:47 PM

i have a cisco AS5300 RAS for dial-in and i am planing to connect the E1 line to something that takes the E1 signal and interfaces it to FXO, which connects to my PABX and to my client. my question is is what cards are required on the 2600xm to acheive the signaling from E1 to FXO? i would also like the config to get the equipment working.

Labels:
0 Helpful
31 Replies 31

ali6359
Level 1
Level 1
In response to Giuseppe Larosa

‎09-07-2019 12:56 AM

i just pulled out the modem bank from the RAS and i just found some corrosion on one of the chips near the end of the bank near the connector. ill clean that and see what happens

0 Helpful

ali6359
Level 1
Level 1
In response to Giuseppe Larosa

‎06-06-2019 04:22 AM - edited ‎06-06-2019 04:22 AM

..

0 Helpful
Customers Also Viewed These Support Documents